Developed and made in Israel — a heating system developed and made in Israel, approved by the Standards Institution

Electric heating panel for the home

Pannel-Heat replaces the standard skirting boards and heats the room by natural convection — even, healthy warmth within minutes, with no renovation and no lifting floors.

What is Pannel-Heat?

Pannel-Heat is an electric heating panel installed along the base of the walls — exactly where the regular skirting board goes. From the outside it looks like a 12 cm decorative skirting board. Inside, heating elements warm the entire perimeter of the room.

The system was developed in Israel by a company based in Herzliya, is approved by the Standards Institution of Israel, and connects to the standard household supply (230V).

How does it heat the room?

It works by natural convection — the same principle that makes underfloor heating feel so comfortable:

  1. Cool air in the room sinks to the floor.
  2. Near the floor it meets the warm panel, heats up and rises.
  3. This creates a gentle, silent air circulation that warms the whole space evenly — no fan, no draft.

Because heat comes from the entire perimeter rather than one point, there are no hot spots next to a heater and no cold corners on the other side of the room. Part of the heat is absorbed by the walls themselves, and the warm walls keep the room comfortable.

Why is it better than other methods?

Pannel-Heat Air conditioner Underfloor Radiator / fan heater
Renovation to install No — only the skirting is replaced No Yes — floor lifted No
Heat distribution Even, from the whole perimeter Airflow, uneven Even Concentrated near the unit
Dry air / dust No Yes No Fan heater — yes
Time to feel warm Minutes Minutes Hours Minutes
Takes up space No Wall unit No Yes
Room-by-room control Yes, a thermostat per zone Yes Depends Yes

For the full comparison see Pannel-Heat vs. underfloor heating.

Specifications

  • Height: 12 cm — the height of a standard skirting board.
  • Power supply: 230V / 50Hz, standard household mains.
  • Standard: approved by the Standards Institution of Israel (SI 900-2). Certificate and radiation test.
  • Control: a thermostat per room or zone — wired, wireless, or wireless with a timer.
  • Unheated wall sections (behind cabinets, in the kitchen): a matching polymer extension panel keeps the line continuous.
  • Protection: overheating protection and a "do not cover" marking, as with any certified heater.

Who is it for?

  • Existing homes with flooring you do not want to rip up — the obvious case. You replace skirting boards, not floors.
  • Homes under construction or renovation — plan the electrical points in advance, no special floor layers needed.
  • Apartments — it takes no space and needs no outdoor unit.
  • Clinics, offices and institutions — quiet, even heat with no noise and no airflow. See, for example, the dental clinic in Jerusalem.
  • Homes in colder areas — power is calculated by the town's elevation and climate zone, from the coast to the Jerusalem hills and the Golan.

One room or the whole house

The system is fully modular. You can start with one room — a child's bedroom, a home office — and expand later. Each room is controlled separately, so you only heat what you use.

How much does it cost?

The price depends on the power your home needs: the area of each room, the ceiling height and the local climate. In the price calculator you choose your town, enter the rooms and get a full estimate — heating elements and installation, before and including VAT.

Want a quote?

By sending you accept the privacy policy. Or call: 054-744-1444

Common questions

FAQ

How is Pannel-Heat different from underfloor heating or an air conditioner?

Pannel-Heat heats by natural convection: cool air near the floor touches the warm panel, warms up and rises, so heat spreads evenly through the room — with no airflow and no drying. Unlike underfloor heating, there is no need to lift the floor and you feel the heat within minutes. Unlike an air conditioner, there is no draft, no noise and no dust blown around.

Where exactly is it installed?

In place of the standard skirting boards along the walls, about 12 cm high. It takes no wall space and does not stick out into the room — from the outside it looks like a regular decorative skirting board.

Is the heat even throughout the house?

Yes. Because heat comes from the whole perimeter of the room rather than one point, there are no hot spots or cold corners. The temperature stays balanced between floor, walls and ceiling.

Is it healthy heat?

It does not dry the air, does not blow dust or allergens around, and does not overheat your feet. An official radiation test was carried out on the system and the results are normal — the report is published on the site.

Can I install it myself?

The system was designed for simple installation, and many customers install it themselves with our full guide. The electrical points are prepared by an electrician. You can also have it installed by installers who work with us.

Is it energy efficient?

Heat goes straight into the room — it does not pass through flooring and insulation first and does not escape straight to the ceiling. Each room is also controlled separately, so you heat only what you need, when you need it.

How long until I feel the heat?

A few minutes. That is one of the big differences from underfloor heating, which warms up through the floor and has to be switched on hours in advance.

Can I start with one room?

Yes. The system is modular: it is installed room by room, with separate control for each room. Start with one room and expand later.

Where is the system made?

Pannel-Heat is developed in Israel by a company based in Herzliya. It is approved by the Standards Institution of Israel and built for the Israeli 230V grid.

Is there a warranty?

Yes, a manufacturer's warranty on the heating elements. Details are in the warranty policy.

How much will it cost you?

Choose your town, enter the room sizes, and get a full price estimate — before and including VAT — in a minute.